Description
The Speed Jack is a patent pending, precision manufactured, solid billet cased, torque amplifying, gearbox integrated on a 5000lb. Top Wind A-Frame Jack. The unlike other drill powered jack competitors, the Speed Jack has a 3 to 1 ratio gearbox. For light or heavy loads get the job done faster, and effortlessly raise or lower your trailer with a cordless drill.
One hundred percent designed and made in the USA. The Speed Jack is specifically made to replace your A-Frame Jack, with just three bolts to swap out.
The Jack features a Gearbox that uses a “Drive Key” with a 3/4″ hex to couple the GearBox to any 18V or higher drill via an included socket adaptor and your 3/4″ six point socket. A backup handle is included as well.
Warranty Information:
The Speed Jack is backed by a  5 year warranty. For more information on our warranty policy please refer to our Terms and Conditions Page
*Warning use of Hammer Drill or Impact will void warranty*
What’s included:
1- Speed Jack
1-Jack Foot
1- Backup Handle
1- Socket Adapter
1- Grease Pack
Instructions for use:
*Warning use of Hammer Drill or Impact will void warranty*
Chock the tires on your trailer before installing the Speed Gearbox and anytime that it is not hooked up to a tow vehicle, even if the ground appears flat. This will keep the trailer from moving during installation and when parked. To install the Turtle Jack, lower your trailer tongue down onto your vehicles hitch. Ensure that the hitch is latched.
Raise your jacks leg until the foot is completely off the ground. Loosen and remove the 3 bolts holding the jack to the trailer. Remove your existing jack by lifting it from the trailer. (You may need to detach the foot from the jack)
Place your trailer jack into the opening of the trailer and align the 3 bolt holes. Insert and tighten your jacks mounting bolts.
Your jack is now ready to use!
Put your 3/4″ socket on the included drill adaptor and use your drill to raise or lower your trailer. Do not raise higher than you need to go so you don’t bottom out the jack. ALWAYS use some clutch with your drill instead of using it fully locked to prevent damage if you bottom it out. Do NOT use an impact gun or hammer drill or you will break the small gear.
Reviews
There are no reviews yet.