Speed Jack – 5000lbs 15" Lift

1-Speed Jack

1-Jack Foot

1-Backup Handle

1- Socket Adapter

1- Grease Pack

*Warning use of Hammer Drill or Impact will void warranty*

Chock the tires on your trailer before installing the Speed Gearbox and anytime that it is not hooked up to a tow vehicle, even if the ground appears flat. This will keep the trailer from moving during installation and when parked. To install the Turtle Jack, lower your trailer tongue down onto your vehicles hitch. Ensure that the hitch is latched.

Raise your jacks leg until the foot is completely off the ground. Loosen and remove the 3 bolts holding the jack to the trailer. Remove your existing jack by lifting it from the trailer. (You may need to detach the foot from the jack)

Place your trailer jack into the opening of the trailer and align the 3 bolt holes. Insert and tighten your jacks mounting bolts.

Your jack is now ready to use!

Put your 3/4″ socket on the included drill adaptor and use your drill to raise or lower your trailer. Do not raise higher than you need to go so you don’t bottom out the jack. ALWAYS use some clutch with your drill instead of using it fully locked to prevent damage if you bottom it out. Do NOT use an impact gun or hammer drill or you will break the small gear.